Of all threading gears and auto feed systems. Fits mini metal lathes that the drive belt goes directly to the spindle gear. Does not fit mini metal lathes that have an intermediate shaft (high/low gear). To fit these you would need a different top gear and a different belt. For those who want to use their own servo motor right now.
The horsepower improvement and speed control is incredible. As long as you pick one of the right motors, this system provides full power at any speed and that includes Spindle RPM's as low as 60 RPM's. Note: Individual parts: Motor mount - a timing belt with timing gears - the spacer or the spindle head bearing holder plate. This kit fits 1 HP 750 watt Vevor and Mophorn industrial sewing machine motors. If you are using a 3/4 hp.
You will need a different mount. I can make it for you and swap it out. That item will be listed soon Only fits the servo motors with the square face plate as seen in images. Does not fit other types. On You Tube search for.
Mini Metal Lathe 1 HP Servo Motor 750 Watt Computer controlled with threading and gears. Same username the Custom Crafter. The Custom Crafter made in the USA servo motor mount.This mount allows for full adjustment of motor both vertically and horizontally. This allows for perfect belt alignment. Mount only fits specific industrial sewing machine servo motors. The Custom Crafter made in USA aluminum spindle bearing locking plate which doubles as an adapter to allow for a larger drive belt. The Custom Crafter made in USA aluminum spindle spacer. This mod is required to fit the larger drive belt required to manage the increased torque + the servo motors ability to change speed in seconds (see photos). A steel or aluminum spindle timing pulley, re-machined by The Custom Crafter to fit the mini lathe spindle shaft (see photos). This pulley fits 28mm spindles. Measured in inch = 1.100" Spindle shaft at timing gear and spacer = 1.102" 1.110" most are 1.1003". A steel or aluminum motor timing pulley, re-machined by the Custom Crafter. This pulley fits servo motors with a 15mm shaft (see photos of motor).
Measured in inch: Motor shaft = 0.589" Pulley bore = 0.592". A new toothed 1/2" wide timing belt to fit the increased width 1/2" wide drive pulleys.Small parts, the mounting nuts and washers come. Hand tight on the mount.
Assembly requires some technical skill to include minor machine work. You will have to cut the diecast gear housing to allow additional room for the larger timing belt. (see photo) this can be done with a hacksaw and a file but a pneumatic cut off tool or die grinder will ease this job.
Note: Check the photos in this listing. If your lathe has holes instead of the normal slots, this motor adapter kit will not fit without your ability to slot the cast iron lathe bed. A spreader wrench is a big help but this can be managed with a hammer and punch. You will need metric allen wrenches + a 13mm/1/2 deep socket and ratchet.
Some longer allen head metric allen head bolts may also be required, especially it you over tighten and strip the chinese ones provided with your machine. All lathes are dangerous, increasing the. To insure fit and proper application. Is suitable for your intended use.
That is because you have to fit it and make it work. I will accept a return for up to 30 days from. No reason for a return is required.
Receipt for install or return assistance. All original parts must be in the same condition as you. The item "Mini Metal Lathe 1 hp 750 watt Mophorn Vevor Motor Kit Belt Pulleys Mount gear" is in sale since Monday, April 20, 2020. This item is in the category "Home & Garden\Tools & Workshop Equipment\Power Tools\Lathes". The seller is "thecustomcrafter" and is located in Haines City, Florida.
This item can be shipped to United States.